Zhongjin Taifu, the source manufacturer of pipe processing machinery!
Tel:+86-15162348390 E-mail:850116699@qq.com
NEWS
Stainless steel pipe cutting machine manufacturers teach you how to deal with problems that occur during the development of the pipe cutting machine?
- Categories:News
- Author:
- Origin:
- Time of issue:2021-09-16 08:45
- Views:
(Summary description)When the bending pipe achieves good working efficiency, it is also necessary to pay attention to the perfect work appearance.
Stainless steel pipe cutting machine manufacturers teach you how to deal with problems that occur during the development of the pipe cutting machine?
(Summary description)When the bending pipe achieves good working efficiency, it is also necessary to pay attention to the perfect work appearance.
- Categories:News
- Author:
- Origin:
- Time of issue:2021-09-16 08:45
- Views:
Information
When the bending pipe achieves good working efficiency, it is also necessary to pay attention to the perfect work appearance. How to better improve the appearance of the pipe cutting machine processing technology, the specific analysis is as follows:
1. Block one end of the steel pipe firmly with a wooden wedge, and stand it downward (note: keep the outer part to facilitate the removal), and fry the sand with fire (the particle size should not be too large or too small, and sieve Good construction sand is suitable) Use a funnel to slowly pour in while it is hot, while filling, while pounding the pipe wall with a hammer to make the dry sand fully filled, press another same wooden wedge tightly until it is dry. The sand does not have any possibility of loosening in the pipe.
2. On the working platform, draw a big sample of the elbow: the radius of the outer circle is 50+outer diameter/2, the inner diameter is 50-outer diameter/2, and the stoppers are spot welded at the start and stop points to prevent simmering Over or under simmering.
3. Simmer under fire, or use a steam torch to simmer. It’s easier to simmer down the heat. Simmer it slowly, but if you use a steam torch to simmer, you should pay attention to the non-standard elbow and simmer section by section, and be careful that the part next to the bottom of the platform must be roasted to the point. The same heat, otherwise it will simmer!
4. In case of under-simmering (not enough angle) or over-simmering (large angle), you can use cold water to pour the inside of the fillet or heat the outside and the opposite method to correct it.
Note: The sand must be fried, the purpose is to remove the water inside, to prevent explosion when the elbow is under fire.
Automatic pipe cutting machine, CNC pipe cutting machine, stainless steel pipe cutting machine, automatic laser pipe cutting machine, automatic chamfering machine
Scan the QR code to read on your phone
More News
-
What are the factors of low quality stainless steel pipe cutting machine
1. The stainless steel pipe cutting machine clearly stipulates the RX value under various pressure levels and the amount of thinning on the outside. The purpose is to control the value of RX and SX to - Stainless steel pipe cutting machine manufacturers teach you how to deal with problems that occur during the development of the pipe cutting machine? 09-16
- The pipe cutting machine manufacturer teaches you to improve the work results of the pipe cutting machine to achieve a beautiful effect 09-16
- Warm congratulations to zhangjiagang zhongjin taifu precision machinery co., LTD 06-05
- What should the machine tool pay attention to when operating the chamfering machine? 06-05
© 2021 Zhangjiagang in jintai precision machinery co., LTD. All rights reserved. 苏ICP备14038484号-1 Powered By www.300.cn SEO
© 2021 Zhangjiagang in jintai precision machinery co., LTD. All rights reserved.